Miele Dishwasher
Error Codes

F11 Drainage System Fault Medium Water remains at the bottom of the dishwasher after a cycle ends View -> F12 Water Intake Fault Medium The dishwasher attempts to fill but stops or pauses early in the program View -> F13 Water Intake Timeout Medium The dishwasher stops early in the program while attempting to fill with water View -> F14 Heating Fault — Water Not Reaching Temperature High Without hot water, grease and detergent are not dissolved properly View -> F24 Drainage Timeout Medium A visible pool of water sits at the bottom when you open the door View -> F40 Software / Control Board Error Low The machine halts at a random point in the cycle — not tied to a specific phase View -> F47 Communication Error Between Modules Medium The control panel stops responding or shows no information while the machine is mid-cycle View -> F51 Circulation Pump Fault High Opening the door mid-cycle reveals standing water but no spraying action from the wash arms View -> F52 Rinse Aid Dispensing System Fault Low Dishes and glassware come out with visible water marks and streaks — the classic sign of missing rinse aid View -> F53 Motor Speed Sensor Fault Medium The circulation pump may run too fast, too slow, or at an inconsistent speed during the wash phase View -> F63 Door Slide Lock / Latch Fault Medium You select a program and press Start, but the machine does not begin — it cannot confirm the door is locked View -> F67 Flow Meter / Turbine Sensor Fault Medium Without flow data, the board may let too much or too little water in View -> F68 AquaStop Inlet Hose Fault High The AquaStop valve remains closed, blocking all water from entering the machine View -> F69 AquaStop Valve Closure Fault High Water keeps entering the tub beyond the normal level because the valve has not closed View -> F70 AquaStop — Water Leak Detected High The machine shuts down mid-cycle and will not restart View -> F78 Circulation Pump Blocked / Overloaded High The spray arms rotate slowly or not at all, even though you can hear the pump running View -> F84 Heating Element / Temperature Control Fault Medium Appliance halts during wash or operation phase View -> F85 NTC Temperature Sensor Failure Medium The control board disables the heater when it cannot verify the temperature, so water stays cold View -> F86 Water Level / Pressure Sensor Fault Medium The machine may overfill or underfill because the board is getting wrong level data View -> F87 Turbidity Sensor Fault Low Without turbidity data, the machine defaults to maximum wash times as a precaution View ->